Kavia Moulded Products

Plastic Injection Moulded Components

  • Home
  • About
    • New Products from Kavia
    • Preferred Partners
    • Business Development
  • Contact
    • Contact Kavia MP
    • Inventors
    • Designers
    • Buyers
    • Distributors
  • Case Studies
  • Design
    • Design
    • Design Resources
    • Ferrule and Bush Configurator
  • Moulding Facilities
  • Services
    • Design
    • Tooling
    • Project Management
    • Value Added Services
  • News
    • Injection Moulding News
    • Videos
  • Rail & Tram

Trade show report – Engineering Design Show 2013

October 4, 2013

DES2013

The Ricoh Arena in Coventry again hosted this year’s two-day show. It also incorporates the Engineering Materials and Electronics Design Show. Event has over 200 exhibitors and runs 30_ keynote conference sessions plus 40+ practical workshops.

For Kavia’s Iain Hill it is an opportunity to attend some keynote sessions for industry insight, meet with suppliers, research new materials and technologies and generate some leads for the business.

Iain attended three sessions listed below and they will be reported independently. The reason for picking this sessions were we have just started a Raspberry Pi related project and it is always good to gain insight into industry design principals and methods of large organisations such as Dyson.

  • Raspberry Pi – from Consumer to Creator. Pete Lomas, Raspberry Pi Foundation
  • The five principles of product development. Simon Smith, Associate Director – Products & Systems, Cambridge Consultants
  • The Dyson Way,
Dr Caroline Simcock, Global Compliance and Approvals Manager, Dyson

It was the electronics exhibitor section that yielded some strong leads, Kavia has extensive experience in supplying electronic plastic enclosures so all-in-all a worthwhile visit.

Filed Under: Kavia News


Kavia News

New Injection Moulding Machines At Kavia

Kickstarter – helping our injection moulding customers

Need help with your business – Kavia customers use MAS

Need a design resource for your injection moulded project?

Case Study – Swimtag wearable tech

K Show sensation – Arburg Freeformer

5 Principles of product development

EZ Fat Footer #3

This is Dynamik Widget Area. You can add content to this area by going to Appearance > Widgets in your WordPress Dashboard and adding new widgets to this area.

© Kavia Moulded Products Limited · Tel: 01706 816696 · Log in